Transport, Storage And Disposal - Stiga MJ 66 Quick Manual For Use

7. TRANSPORT, STORAGE AND
DISPOSAL
7.1. TRANSPORT
When handling the machine, always:
1. disengage the cutting means;
2. bring the cutting means assembly to the highest position;
3. switch off the machine and remove the ignition key
4. disengage the drive (par.4).
When transporting the machine on a vehicle or trailer, always:
• use an access ramp of suitable strength, width and length;
• load the machine with the engine switched off, with the
key removed from the ignition, without a driver and pushed
by an adequate number of people;
• close the fuel tap (if provided);
• lower the cutting means assembly;
• position it so that it does not cause a hazard to anyone;
• engage the drive (par.4);
• lock it firmly on the means of transport using ropes or
chains to prevent it from tipping over and possible damage.
7.2. STORAGE
When you intend to put your machine away for more than
30 days:
• Wait for the engine to cool
• Disconnect the battery cables and store it in a cool and
dry place.
• Empty the fuel tank and follow all the instructions in the
engine manual.
• Clean the machine thoroughly.
• Check the machine for any damage. If necessary, contact
the authorised service centre.
Store the machine:
• with the cutting means assembly lowered;
• in a dry place;
• protected from inclement weather;
• covered with a sheet if possible;
• in a place out of children's reach;
• making sure that keys or tools used for maintenance
are removed.
Before starting to use the machine again:
• check that there are no fuel leaks from the tubes, fuel
stopcock or carburettor:
• prepare the machine as described in chapter "5 Use of
the machine".
NOTE Ensure that the battery is fully charged at least once
a month and always before use.
NOTE Store the machine so as to avoid any risk in the
event of accidental contact with people, children or animals.
EN - 8