Status Display - Bosch Access Modular Controller 2 Manual

12 en | Introduction
3.2.2

Status display

Figure 3.6: Dialog button of the controller
The liquid crystal display delivers status information about the controller. Push the dialog
button to switch between different modes.
The selected display mode remains set until the next time the button is pressed.
The display pages depend on the firmware loaded into the controller. The order of the display
pages available on delivery (Bootloader V00.49) is shown in the following table.
For information on display pages available for the different firmware (FW) variants, refer to
Status display, page 48 .
Push
0
1
2
3
4
5
6
7
8
9
10
11
12
2022-11 | V04 |
Display (Example)
V00.49 dd.mm.yy
S/N1: 0910024419
S/N2: 22850034
11.18 12:24:18 S
MAC 001B860012AB
N AMC-1234-5678
I 192.168.10.18
G 192.168.10.255
M 255.255.255.0
H 192.168.10.10
DHCP 1
D 192.168.10.1
Host: + "C"
Guide d'installation
Description
Bootloader version by factory
dd.mm.yy release date of the firmware
Serial number 18 digits - Part1 10 digits
Part 2 - 8 digits
Current date and time (MM.DD hh:mm:ss)
(S) = daylight saving
Network device address (MAC)
Network name of the controller (max. 14 char.)
See Configuring Ethernet interface, page 34 .
IP-address of the controller
IP-address of the gateway
Subnetmask
IP-address of the host computer
DHCP-status: 1 = on; 0 = off
IP-address of the DNS server
Host activity:
+ = online
- = offline
"C" = Counter (0 to 9) of the received data
packages from the host interface.
RS 485 Bus connection:
A = Address 1 ... H = Address 8
Access Modular Controller 2
Bosch Security Systems B.V.