Nokia FastMile 5G14-B User Manual page 29

User Guide
Figure 20
Orient the desktop stand and FastMile 5G Receiver so that the signal test button
faces towards the inside of the room (the Nokia logo should face outside), and place
in position.
If included in your kit, attach the cable clamp to the pre-attached PoE cable of the
FastMile 5G Receiver and use it to secure the pre-attached PoE cable of the receiver
to the windowsill, wall, or furniture.
If the FastMile 5G Receiver is not connected to power, connect it to power as
described in
Secure the PoE injector in place as appropriate. Be sure to allow for any required
slack in the cabling attached to the FastMile 5G Receiver.
Connect a 1 Gbps Ethernet LAN cable between the PoE injector and your gateway.
You will need to provide the cable if it was not supplied as part of the kit for the
FastMile 5G Receiver.
3TG-02285-AAAA-TCZZA-02
Securing the cable in place
Connecting the FastMile 5G Receiver to
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
Installing the FastMile 5G Receiver
power.
29