SMA 800-TRL30NS Owner's Manual page 4

Break-Away Boom Assembly is preassembled. Follow the directions
Detail A
below to mount to your tank.
Detail A:
Locate the (2) Boom Top Straps and then in the parts bag, locate
(2) 5/16-18 x 5/8" Flanged Lock Screws.
Attach the Boom Top Straps to the tank, using the two screws.
DO NOT TIGHTEN
Detail B:
Locate the Boom Assembly and then in the parts bag, locate
(2) 5/16-18 x 5/8" Flanged Lock Screws.
Attach the Boom Assembly to the tank, using the two screws.
DO NOT TIGHTEN
Detail B
Detail C:
Locate in the parts bag (2) 5/16-18 x 5/8" Flanged Bolts and (2) Whiz
Nuts.
Attach the Boom Top Straps to the Boom Assembly using the two
bolts and whiz nuts.
**** Tighten all Bolts from Details A, B & C ****
**** DO NOT OVERTIGHTEN ****
After the boom is installed,
attach the 8" Feeder Hose to
the 90° HB Elbow on the
manifold.
The boom is now installed.
Detail C
Final Steps:
Locate the Locate the
Pressure Gauge in Bent Clevis Pin in
the parts bag and the parts bag and
thread into the place in the hole
open port on the on the hitch.
manifold.
*** The Sprayer should now be ready for use ***
Page 4