SMA 800-SS8P Owner's Manual

IF YOU SHOULD HAVE A QUESTION OR
EXPERIENCE A PROBLEM WITH YOUR
SMA PRODUCT:
1 -870-935-3291
BEFORE YOU CALL, PLEASE HAVE THE
FOLLOWING INFORMATION AVAILABLE:
SALES RECEIPT & MODEL NUMBER. IN MOST
CASES, ASMA EMPLOYEE CAN RESOLVE
THE PROBLEM OVER THE PHONE.
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your sprayer.
Please read it carefully, as it furnishes information which will help
you achieve years of trouble-free operation.
Warranty/Parts/Service
For home usage, products are warranted for one year from date
of purchase against manufacturer or workmanship defects.
Commercial users have a 90 day warranty.
Your authorized dealer is the best source of replacement parts
and service. To obtain prompt, efficient service, always
remember to give the following inf o rmation ...
- Correct Part Description and/or part number.
- Model number/Serial number of your sprayer.
Part descriptions and part numbers can be obtained from the
illustrated parts list section(s) of this manual.
Whenever you need parts or repair service, contact your
distributor/dealer first. For warranty work, always take your
original sales slip, or other evidence of purchase date, to your
distributor/dealer.
Model: 800-SS8P (5301852)
(8 Gallon Super Spot Sprayer)
Technical Specifications
• 8 Gallon, Corrosion-Resistant Polyethylene Tank
• 1.0 G.P.M. Diaphragm Pump With Cooling Fan & In-line Fuse
• Telescopic Handle For Easy Mobility & Storage
• Rechargeable 12V Battery (AC Charger Included)
• Coiled Hose With 15 Feet Working Length
• Squeeze Lever Handgun
• Vented lid
• 8 Inch Wheels
Assembly
This unit is mostly assembled at the factory. You may need to
screw the barrel portion of the handgun onto the trigger assembly,
as this may disassembled to fit into the box.
Battery Charging
It is a good idea to charge the battery for 8-10 hours before
using the sprayer, especially if you plan to spray f o r a long
period of time. this will insure that the battery is fully charged.
Charging the battery may be done as follows ...
1. Insert the plug (which is molded onto the end of the
charger wire) into the jack, which is located on the rear of
the sprayer.
2. Plug the charger into a 110 Volt AC electric receptacle.
3. Disconnect the plug from the jack and the charger from
the electrical outlet when the charging operation is
complete.
CAUTION: Do not leave the charger connected to the battery for
longer than 20 hours, as it may cause premature battery failure.
Operation
Fill the container with solution (water and chemical) then stir to
mix. Mixing can also be done by sticking the handgun nozzle
into the container and spray into the solution.
Turn the switch to "ON" and squeeze the lever on the handgun
to spray.
After spraying, rinse and clean the equipment both inside and
out. Flush the pumping system with water.
Jonesboro, AR 72401
Phone: 870-935-3291 Fax: 870-935-5651
Form No. 1736 5008097 (04/13) Printed in the U.S.A.