SMA 800-UTL60BL Owner's Manual

Model: 800-UTL60BL (5301795)
(60 Gallon Lawn & Garden Utility Sprayer w/"Boomless' Boom)
Technical Specifications

60 Gal. Corrosion-Resistant Polyethylene Tank

Deluxe Pistol-Grip Handgun

25 Ft. Handgun Hose

26 Ft. max. vertical throw,
35 Ft. horizontal throw

3-Nozzle Boomless Nozzle Assembly
w/30 Ft. Spray Coverage

Adjustable Boom Height

12 Volt, 4.5 GPM - 60 PSI Diaphragm Pump
Caution: When fully filled with water, this
sprayer will weigh approx. 620 lbs.. Consult the
owner's manual for your vehicle to verify that
you are within it's load carrying capacity.
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden Utility sprayer.
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-870-935-3291
If you should have a question or experience a problem with
your SMA Product: call the Toll free number above.
Our technical support representatives will be happy to
help you. In most cases a customer service rep. can
resolve the problem over the phone.
To obtain prompt, efficient service, always remember to give
the following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
Retain a copy of your receipt for your
unit, as it will be required to validate
any warranty service.
Warranted against manufacturer or
workmanship defects from date of
purchase with copy of receipt:
Homeowner Usage: Sprayer-One Year and Pump-Two Years.
Commercial Usage: Sprayer and Pump-90 Days.
OWNER'S MANUAL
Assembly Instructions
Most of the sprayer has been assembled at the factory.
Center the boom tube on the boom mounts and secure in
place with the (2) round U-bolts and whiz nuts provided.
Make sure the U-bolts are positioned within the grooves of
the grommets on the boom tube. Refer to page 2 to attach
the end nozzles to the boom.
NOTE: The purpose of these grommets is to prevent met-
al-to-metal contact between the U-bolts, boom tube and
boom mounting brackets.
The grommets will 'compress' as you tighten the whiz lock-
nuts onto the U-bolts. Tighten just so that the boom tube will
NOT rotate within the grommets. Alternate the tightening of
the locknuts to provide even pressure on the grommet.
**DO NOT OVER TIGHTEN the whiz locknuts, as this may
cause the boom tube to flatten slightly!
Attach the boom feeder hose to the boom after routing it
through the underside of the carrier frame as needed. Secure
in place with a hose clamp provided.
2415 Industrial Dr.—Jonesboro, AR 72401
Phone: 870-935-3291 : Fax: 870-935-5651
[5194924 (03/19)]
Page 1