SMA 800-UTL40BL Owner's Manual

SMA 800-UTL40BL Owner's Manual

40 gallon lawn & garden utility sprayer boomless' boom

Advertisement

Quick Links

(40 Gallon Lawn & Garden Utility Sprayer w/"Boomless' Boom
Technical Specifications
40 Gal. Corrosion-Resistant Polyethylene Tank
Deluxe Pistol-Grip Handgun
25 Ft. Handgun Hose
26 Ft. max. vertical throw, 35 Ft. horizontal throw
3-Nozzle Boomless Nozzle Assembly
w/30 Ft. Spray Coverage
Adjustable Boom Height
12 Volt, 4.5 GPM, 60 PSI Diaphragm Pump
Caution: When fully filled with water, this
sprayer will
weigh approx. 450 lbs..
Consult the owner's manual for your
vehicle to verify that you are within it's
load carrying capacity.
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden Utility sprayer.
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-870-935-3291
If you should have a question or experience a problem with
your SMA Product: call the Toll free number above.
Our technical support representatives will be happy to
help you. In most cases a customer service rep. can
resolve the problem over the phone.
To obtain prompt, efficient service, always remember to give
the following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
Retain a copy of your receipt for your
unit, as it will be required to validate
any warranty service.
Warranted against manufacturer or
workmanship defects from date of
purchase with copy of receipt:
Homeowner Usage: Sprayer-One Year and Pump-Two Years.
Commercial Usage: Sprayer and Pump-90 Days.
OWNER'S MANUAL
Model: 800-UTL40BL (5301793)
Assembly Instructions
Most of the sprayer is assembled at the factory. The only
assembly necessary is to thread the pressure gauge in
place , attach the boom and to hook up the wiring to an
existing 12 volt power source.
Attach the boom to the boom mounts with the hardware
provided. Follow the directions on the next page to attach
the end nozzles to the boom. Attach the boom feeder hose
and secure in place with the provided hose clamps.
Connect the electrical hook-up to the end of your pump and
clip the clips to a fully charged battery.
Read the operating instructions and then run the sprayer
using only water for testing.
2415 Industrial Dr.—Jonesboro, AR 72401
Phone: 870-935-3291 : Fax: 870-935-5651
[5004976
)
(03/19)]
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for SMA 800-UTL40BL

  • Page 1 If you should have a question or experience a problem with your SMA Product: call the Toll free number above. Our technical support representatives will be happy to help you. In most cases a customer service rep. can resolve the problem over the phone.
  • Page 2 End Nozzle Assembly Procedure For Boomless “Wet”Boom Your boom will come with the (2) end nozzle assemblies NOT affixed to your boom tube. Follow the instructions below to attach these properly to the boom tube, as shown. Assembled End Nozzle 1.
  • Page 3: Operation

    IMPORTANT: Remove tank lid and be sure the tank is clean and Manifold Valves CLOSED free of any foreign material. Rinse tank out of any tank residue before filling with water to test. Testing the Sprayer NOTE: It is VERY important for you to test your sprayer with plain water before actual spraying is attempted.
  • Page 4: Speed Chart

    Rate Chart for Boomless Nozzle (Set of 3) Speed Chart Gallons per Acre Based on Water - 17-1/2" Spacing Capacity Pressure Time Required in seconds 1 MPH 2 MPH 3 MPH 4 MPH 5 MPH 6 MPH 8 MPH G.P.M. P.S.I.
  • Page 5: Troubleshooting The Pump

    Pump Model: 5281372 4.5 GPM, 60 PSI Available Replacement Parts Replacement Pump: 5151088 Includes: 1/2” MNPT Port Kit Fitting #5168832 1/2” Hose Barb Port Kit Fitting #5168833 DON’T  Use to pump bleach.  Clean and rinse your pump after each use with Fimco Tank ...
  • Page 6: Checking The Pressure Switch

    Checking the Pressure Switch If your motor is not running and you’ve checked the following: for loose wiring connections, fuse, the switch on the lead wire was “ON” and made sure you were connected to a fully charged battery and everything is fine, but the motor won’t run, then it’s time to check to see if the pressure switch is bad.
  • Page 7: Exploded View Parts List

    Exploded View/Parts List 800-UTL40BL (5301793) See Detail A Next Page Right Hand (RH) and Left Hand (LH) sides of the sprayer are determined as if you are standing behind the sprayer, looking at it (facing forward) Page 7...
  • Page 8 Detail A Plumbing Manifold Detail Exploded View/Parts List Boomless “Wet” Boom Assembly (5275260) Center Nozzle Assembly #5275123 End Nozzle Assembly #5275122 Page 8...
  • Page 9 NOTES: Page 9...
  • Page 10: Warranty

    Warranty LIMITED WARRANTY FOR NEW FIMCO, IND. EQUIPMENT WHO MAY USE THIS LIMITED WARRANTY. This limited warranty (the “Limited Warranty”) is provided by Fimco, Ind. to the original purchaser (“you”) of the Equipment (as defined below) from Fimco, Ind. or one of Fimco, Ind.’s authorized dealers. This Limited Warranty does not apply to any subsequent owner or other transferee of the Equipment.

This manual is also suitable for:

5301793

Table of Contents