Download Print this page
SMA 800-ATV25DXBL Owner's Manual
SMA 800-ATV25DXBL Owner's Manual

SMA 800-ATV25DXBL Owner's Manual

Lawn & garden / atv boomless sprayer

Advertisement

Quick Links

General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden ATV sprayer.
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-870-935-3291
If you should have a question or experience a problem with
your SMA Product: call the Toll free number above.
Our technical support representatives will be happy to
help you. In most cases a customer service rep. can
resolve the problem over the phone.
To obtain prompt, efficient service, always remember to give
the following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
Retain a copy of your receipt for your
unit, as it will be required to validate
any warranty service.
Warranted against manufacturer or
workmanship defects from date of
purchase with copy of receipt:
Homeowner Usage: Sprayer-One Year and Pump-Two Years.
Commercial Usage: Sprayer and Pump-90 Days.
OWNER'S MANUAL
Model: 800-ATV25DXBL (5301790)
(25 Gallon Lawn & Garden/ATV Boomless Sprayer)
Technical Specifications
25 Gal. Corrosion-Resistant Polyethylene Tank
12 Volt Diaphragm Pump, 4.5 GPM - 60 PSI
Deluxe Pistol Grip Handgun
15 Ft. Handgun Hose (3/8" I.D.)
26 Ft. Vertical throw, 35 Ft. Horizontal Throw
30 Foot Spray Coverage w/Boom
Corrosion-Resistant Nozzles
Caution: When fully filled with water, this sprayer will
weigh 260 lbs.. Consult the owner's manual for your
vehicle to verify that you are within it's load carrying
capacity.
Assembly Instructions
Make sure the contents of the sprayer's carton match the
items shown on page 2 of the manual.
Follow the steps on pages 3, 4 & 5 to properly assemble
the sprayer.
After assembly is complete and before testing your spray-
er, make sure you connect the electrical hook-up to the
end of your pump and clip the clips to a fully charged bat-
tery.
The drain plug assembly should already be attached to the
tank
***IMPORTANT REMINDER***
This sprayer comes with an On/Off (shut-off) valve located at the inlet location
of the tank, towards the underside. (See Detail A). You must make sure the
2623 Commerce Dr.
Jonesboro, AR 72401
Phone: 870-935-3291 Fax: 870-935-5651
[5194928 (03/19)]
Detail A
Page 1

Advertisement

loading

Summary of Contents for SMA 800-ATV25DXBL

  • Page 1 FOR ANY REASON, PLEASE CALL 1-870-935-3291 If you should have a question or experience a problem with your SMA Product: call the Toll free number above. Our technical support representatives will be happy to help you. In most cases a customer service rep. can resolve the problem over the phone.
  • Page 2 Contents of your sprayer’s carton (800-ATV25DXBL - 5301790): Owner’s Manual Lid w/Lanyard (#5058188) Tank/Plumbing Pre-Assembly “Wet Boom” Sub-Assembly End Nozzle (5275122) (5275712) Pkg. of 2: #5275713 Contents of Parts Bag #5278137 Contents of Bracket Kit #5278138 Page 2...
  • Page 3 Step 1 Assembly Procedure (800-ATV25DXBL) Normally, the sprayer will be mounted on an ATV with the pump assembly at the operator’s back and the spray wand will be at the rear of the unit. Right Hand (RH) and Left Hand (LH) sides of the sprayer are...
  • Page 4 Step 4 End Nozzle Assembly Procedure For Boomless “Wet”Boom Your boom will come with the (2) end nozzle assemblies NOT affixed to your boom tube. Follow the instructions below to attach these properly to the boom tube, as shown. Assembled End Nozzle 1.
  • Page 5 Step 5 Assembly Procedure (800-ATV25DXBL) After your boom is attached, locate the 48” hose and the (2) hose clamps from the parts bag. Place the hose clamps over each end of the hose loosely. Slip the ends of the hose over the hose barbs on both the manifold and on the center nozzle.
  • Page 6: Operation

    IMPORTANT: Remove tank lid and be sure the tank is clean and free of Manifold Valves CLOSED any foreign material. Rinse tank out of any tank residue before filling with water to test. Testing the Sprayer NOTE: It is VERY important for you to test your sprayer with plain water before actual spraying is attempted.
  • Page 7 Rate Chart for Boomless Nozzle (Set of 3) Speed Chart Time Required in seconds Gallons per Acre Based on Water - 17-1/2" Spacing Capacity to travel a distance of Pressure 1 MPH 2 MPH 3 MPH 4 MPH 5 MPH 6 MPH 8 MPH G.P.M.
  • Page 8: Troubleshooting The Pump

    Pump Model: 5281372 4.5 GPM, 60 PSI Available Replacement Parts Replacement Pump: 5151088 Includes: 1/2” MNPT Port Kit Fitting #5168832 1/2” Hose Barb Port Kit Fitting #5168833 DON’T  Use to pump bleach.  Clean and rinse your pump after each use with Fimco Tank ...
  • Page 9 Checking the Pressure Switch If your motor is not running and you’ve checked the following: for loose wiring connections, fuse, the switch on the lead wire was “ON” and made sure you were connected to a fully charged battery and everything is fine, but the motor won’t run, then it’s time to check to see if the pressure switch is bad.
  • Page 10: Exploded View Parts List

    Exploded View/Parts List: 800-ATV25DXBL (5301790) Manifold Detail Intake Detail Page 10...
  • Page 11 Boomless “Wet” Boom Assembly Exploded View/Parts List (5275260) Center Nozzle Assembly 5275123 End Nozzle Assembly 5275122 Page 11...
  • Page 12: Warranty

    Warranty LIMITED WARRANTY FOR NEW FIMCO, IND. EQUIPMENT WHO MAY USE THIS LIMITED WARRANTY. This limited warranty (the “Limited Warranty”) is provided by Fimco, Ind. to the original purchaser (“you”) of the Equipment (as defined below) from Fimco, Ind. or one of Fimco, Ind.’s authorized dealers. This Limited Warranty does not apply to any subsequent owner or other transferee of the Equipment.

This manual is also suitable for:

5301790Atv25dxbl