Table of Contents
Advertisement
3. Operation Guide
3.1 NFC Configuration
IOT-S500L can be configured via an NFC-enabledsmartphone.
1. Pull out the battery insulating sheet to power on the device. The indicator will light up in green for 3
seconds when the device turns on.
2. Download and install "ToolBox" App from Google Play or App Store.
3. Enable NFC on the smartphone and open Milesight ToolBox.
4. Attach the smartphone with NFC area to the device to read device information.
5. Basic information and settings of the device will be shown on ToolBox if itʼs recognized
successfully. You can read and configure the device by tapping the Read/Write device on the
App. In order to protect the security of the device, password validation is required when
configuring via a new smartphone. The default password is 123456.
Note:
1) Check the location of the smartphone NFC area and itʼs recommended to take off the phone
case.
2) If the smartphone fails to read/write configurations via NFC, move the phone away and back
to try again.
3) IOT-S500L can also be configured by ToolBox software via a dedicated NFC reader
provided by IoT, you can also configure it via TTL interface inside the device.
3.2 LoRaWAN Settings
LoRaWAN settings are used for configuringthe transmission parameters in LoRaWAN
®
network.
7
Advertisement
Table of Contents
