Table of Contents
Advertisement
3. Power Supply
Remove the rear cover of device to install the batteries, do not reverse the direction of batteries
when installing.
Note: The device can only be powered by ER14505 Li-SOCl
batteries not AA batteries.
2
4. Operation Guide
4.1 Log in the ToolBox
The IOT-S500-IAQ3/IOT-S500-IAQ3L can be configured via a NFC supported mobile phone.
1. Download and install "Linovision ToolBox" App from Google Play or Apple App Store.
2. Enable NFC on the smartphone and launch Linovision ToolBox.
3. Attach the smartphone with NFC area to the device to read device information. Basic
information and settings of the device will be shown on ToolBox App if itʼs recognized
successfully. You can read and configure the device by tapping the Read/Write device on the
App. In order to protect the security of the device, please change password when first
configuration. The default password is 123456.
Note:
1) Ensure the location of smartphone NFC area and itʼs recommended to take off phone case.
2) If the smartphone fails to read/write configurations via NFC, keep the phone away and back
8
Advertisement
Table of Contents
