Table of Contents
Advertisement
blink in green twice, then device will reboot.
Via ToolBox App:
Go to Device ->Maintenance to tap "Reset", then attach smartphone with NFC
area to device to complete reset.
4. Installation
3M Tapes Fix:
Paste 3M tape to the back of the device, then tear the other side and place it on a flat surface.
Screw Fix:
Remove the back cover of the device, screw the wall plugs into the wall and fix the cover with scr
ews on it, then install back the device.
Note:
1. Adjust the installation direction according to detection area requirement.
2. IOT-S500L can be mounted on a wall or ceiling. Itʼs recommended to install at 1.5~2.5m from
the floor.
3. Ensure the detection area does not have moving objects like waving trees and fans.
4. Ensure the detection area is not blocked by curtains or barriers.
Device Payload
5.
All data are based on the following format (HEX):
Channel1
Type1
1 Byte
1 Byte
Data1
Channel2
N Bytes
1 Byte
Type2
Data2
Channel 3
1 Byte
M Bytes
1 Byte
...
...
14
Advertisement
Table of Contents
