Table of Contents
Advertisement
Reporting/s
device will report "not triggered" status. Default: 120s
Enable or disable the light indicating in chapter 2.4.
LED Indicator
Note: The indicator of reset button is not allowed to disable.
Illuminance
Enable or disable illuminance collection. When this is disabled, reporting
Collection
interval will be changed to 1080mins automatically.
Change Password
Change the password for ToolBox App to write this device.
3.4 Threshold Settings
When illuminance collection is enabled, users can define the Bright or Dark state via detection
data of light sensor in threshold settings. Besides, when the PIR sensor is triggered and light
status meets the threshold, IOT-S500L will send alarms immediately. Otherwise, it will not send
data rightaway.
3.5LoRa D2DSettings
LoRa D2D protocol is developed by Linovision and used for setting up transmission among
Linovision devices without gateway. When the LoRa D2D setting is enabled, IOT-S500L can work
as a LoRa D2D controller to send control commands to trigger LoRa D2Dagent devices.
1. Enable LoRa D2Dfeature.
2. Define a unique LoRa D2D key which is the same as LoRa D2D agent devices, then s
elect the frequency and spreading factor. (Default LoRa D2D Key: 5572404C696E6B4C6F5
2613230313823)
11
Advertisement
Table of Contents
