Table of Contents
Advertisement
15 THE USE OF THE CONTROLLER
15.1 Parameter overview and setting, alarm description
When unit is connected to the power supply, the display will show the following:
Current water temperature in bottom part of tank is 16°C and 17°C in upper part of the tank. The current time is
10:30, unit is in standby mode.
With one press on button
we can turn the unit on and in a few seconds it starts running. First the
ventilator starts and s few seconds later the compressor.
Review of the current set parameters for operation can be performed when the device is working or when it is in
standby mode. When the device is working (compressor and fan are working), press the
button once to
put the device in standby mode. In standby mode all the parameters can also be changed. In the working mode
the parameters can only be checked with no possibility of changing them.
To check the parameters press one of the buttons
or
. Pressing the »UP« button you can move from
the first to the last parameter. Pressing the »DOWN« button, you can move from the last to the first parameter.
This is how you check the parameters in both operation modes (standby and working mode).
To change the parameters, the device must work in stand-by mode (described above). Display shows current
water temperature on the bottom and on the top of the water tank. In upper right corner a »shower icon« is
shown. This is how the display can be seen:
13
Advertisement
Table of Contents
