Table of Contents
Advertisement
14 UNIT SETTINGS
When the unit is connected to the water system and filled with water, it can be connected to the power supply.
Power supply can only be plugged into a grounded socket (16A, 230V / 50 Hz).
The power supply cable must be connected to a socket, which is earthed and is protected with a corresponding
safety fuse (16A, 230V/50Hz)
When the heat pump is correctly installed, connected and the system according to these instructions filled with
water, the pump can be turned-on with the ON/OFF button. After 3 seconds the electronic module displays the
temperature of the in- and outgoing water in the water tank.
-
Heat pump (compressor, ventilator) is currently running
-
Domestic hot water is prepared, compressor is switched off-standby mode
-
Electric heater is ON, it can be parallel with compressor or independent
12
Advertisement
Table of Contents
