If both power sources are connected the camera always uses external power over the GPIO connector.
The camera does not transmit images for the first 100 ms after power-up. The auto-exposure and auto-white balance
algorithms do not run while the camera is powered down. It may therefore take several images to get a satisfactory
image.
When the camera is power cycled (power disengaged then re-engaged), the camera reverts to its default factory
settings, or if applicable, a saved user set.
1/18/2023
©2015-2023 FLIR Integrated Imaging
Solutions Inc. All rights reserved.
®
Teledyne FLIR Forge
Installation Guide
3 Forge 5GigE Installation
6