Installation - Samus SC626WGD9 Instruction Manual

- obstructing the ventilation or heat dissipation slot;
- allowing power supply cables of small appliances to come into contact with the hot parts of the appliance;
- exposing the appliance to atmospheric agents such as rain, or sunlight;
- using the oven for storage purposes;
- using flammable liquids near the appliance;
- using adapters, multiple sockets and/or extension leads;
- attempting to install or repair the appliance without the assistance of qualified personnel.
- WARNING: Accessible parts may become hot during use Young children or infirm persons should be kept
away.
Qualified personnel must be contacted in the following cases:
-installation (following the manufacturer's instructions);
-when in doubt about operating the appliances;
-replacing the electrical socket when it is not compatible with the appliance plug.
Service Centers authorized by the manufacturer must be contacted in the following cases:
- If in doubt about the soundness of the appliance after removing it from its packaging;
- if the power supply cable has been damaged or needs to be replaced;
- if the appliance breaks down or functions poorly; ask for original spare parts.
You must do as following:
- only use the appliance to cook food and nothing else;
- check the soundness of the appliance after it has been unpacked.
- disconnect the appliance from the electrical mains if it is not functioning properly and before cleaning or
performing maintenance.
- when left unused, unplug the appliance from the electricity mains;
- use oven gloves to place cookware in the oven or when removing it.
- always grip the oven door handle in the centre as the extremities of the same may be not due to any hot air
leaks.
- make sure the knobs D and C are in the "●" position when the appliance is not in use.
- after disconnecting it from the mains when you decide not to use the appliance any longer.
- the manufacturer may not be held responsible for any damage due to: incorrect installation, improper, incorrect
and irrational use.
- If the power cord is damaged, it must be replaced by the manufacturer or a qualified service engineer to avoid
any risks to safety.
- the appliance is for indoor use only.

Installation

The appliance must be installed only by a qualified person in compliance with the instructions provided.
The manufacturer declines all responsibility for improper installation which may harm persons and animals and
damage property.
Important: the power supply to the appliance must be cut off before any adjustments or maintenance work is
done on it.
Installation of built-in ovens
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be appropriate.
The figure below gives the dimensions of the cut-out for installation under the counter or in a wall cabinet unit.
32