Safety
Installing the Outboard Bearing Housing
4
Introduction
6
7
60 | 70
Disassembly
Use the illustrations and instructions to install the
outboard bearing housing. The tools being used
are included in the Outboard Bearing Removal
5
and Installation Kit (K 956).
4
Install the retaining ring onto the impeller
shaft.
5
Apply grease to the shaft, bearing housing,
and bearing, then gently tap the bearing
halfway into the bearing housing.
6
Align the bearing installation tool with the
center of the bearing, then thread the screw
into the end of the impeller shaft until it
bottoms out.
7
Turn the nut to press the bearing into the
bearing housing so that it sits against the
retaining ring.
Assembly