Waterous CM Series Overhaul Instructions page 35

Safety
Removing the Mechanical Seal
4
Introduction
6
7
35 | 70
Disassembly
Use the illustrations and instructions to remove the
mechanical seal without disassembling the pump.
The tools being used are included in the Mechanical
5
Seal Removal and Installation Kit (K 628).
4 Turn the body of the tool until it touches the
mechanical seal, then tighten the drive plug
until the spacer is a minimum of 1/2 inch from
the mounting plate.
Note: Do not over-tighten the mechanical seal
5 Loosen the drive plug to free the mechanical
seal from the seal housing.
6 Remove the drive plug.
7 Remove the hardware and mounting plate.
8 Remove the mechanical seal.
8
Assembly
removal tool.