User Interface; Menu Screens - Macurco AimSafety PM100 User Instructions

Personal single gas monitor

Hide thumbs Also See for AimSafety PM100:

Table of Contents

PM100 Personal Single Gas Monitor

If sensor stabilization fails, the

displayed. Perform a calibration (see Calibration) or contact AimSafety for more information.

4.2 User Interface

Measuring Mode is the default mode. Once the monitor is activated the meter will continually display

measure gas concentrations in real-time.

Basic Mode is an optional mode where the remaining sensor life will be displayed if the detected gas

levels are below the alarm threshold. The monitor will display the active gas reading only after an alarm

threshold has been exceeded. Basic mode can only be enabled using the PM Link and software, or the

Bump Test-Calibration Station.

From the Measurement screen, pressing the [Function key] will step to the next screen.

Note: If you do not press the [Function key] within 10 seconds, the display reverts to the main screen.

Stealth Mode Press the [Function key] to advance to Stealth Mode (if enabled). Stealth is an optional

setting that disables all audible, vibrating alarms and alarm LEDs. When Stealth is

enabled, an "StL" screen is added to the menu to indicate that the audible and vibrating

alarms are disabled. The display alarm flags are the only indication of an alarm

condition.

REV – 3.0

icon will appear on the display and no gas concentrations will be

Figure 5-2

Figure 5-3

Figure 5-4

[34-2900-0206-2]

8 |

P a g e

Table of Contents