Step 2: Bench-Test Configuration; Connect Video And Power Cables - HIS -RL17 H Series User Manual

Installation Instructions

Step 2: Bench-test Configuration

Make sure everything works before installing into the production environment.

TIP!
If using a KVM extender, please refer to the installation instructions included
with the KVM extender module. It is particularly important to bench-test the full
configuration prior to final installation. This will help to identify and troubleshoot
any system issues while configuration changes may still be easily made.

Connect Video and Power Cables

All monitors are shipped with a standard VGA video cable� AC-powered displays are also
shipped with a power/mains cable� The cable ports are located on the rear of the monitor�
Video Connection
The HIS-RL17 supports digital signals (DVI, HDMI, DisplayPort) through its DVI-I port and analog
signals (VGA, RGB) through its VGA port. RGB (BNC, RCA), HDMI, and DisplayPort video
sources require additional adapters�
After selecting the appropriate interface, connect one end of your video cable to the input port

on the rear of the monitor� Secure the screw locks to ensure adequate strain relief� Connect the
other end to the appropriate port on your host computer or other video source�
NOTE: If this step is not performed, the product will not comply with Class I,
HAZ
II, III, Division 2 Hazardous Location requirements.
LOC
8 RL17H User Manual, 99166B, December 2022
SERIAL
(RS-232)
POWER INPUT
DVI VIDEO
(for Touch Screen option)
USB
VGA VIDEO