Advanced Ethernet Configure; Loop Detect; Broadcast Storm Filter - ICP DAS USA iNS-308 User Manual

iNS-308 User Manual

6. Advanced Ethernet configure

6.1 Loop Detect

iNS-308 has built-in network loop detection. When a loop occurs in the network configuration, iNS-
308 will flash a light to remind the loop and perform packet control on the network port where the
loop has occurred, which can reduce the loop caused to a certain extent. network is down.

6.2 Broadcast storm filter

iNS-308 provided broadcast storm protect function, after checking "broadcast storm filter" in home
page, the iNS-308 will actively control the broadcast type packets(packet Destination Address is MAC
FF:FF:FF:FF:FF:FF) to avoid a large number of broadcast packets occupying the network frequency.
Broadband leads to degradation of communication quality or network paralysis.
Strom Filter
Disable(default)
Enable
Copyright © 2022 ICP DAS CO., Ltd. All Rights Reserved.
Description
Do not detection the packet.
Limited to only broadcast packets through 1280 packets
per second. If iNS-308 detection Broadcast packet over
threshold per second, the switch will drop the excess part
to protect communication.
- 32 -