Network - ICP DAS USA iNS-308 User Manual

iNS-308 User Manual

4.3 Network

The Network page contains the IP Address Configuration section allowing you to verify network
settings, General Settings, Restore Factory Defaults and Firmware Update sections. Each of which
will be described in more detail below.
The IP Address Configuration section displays the network parameters of the module allowing you
to modify these settings. You can select DHCP to receive a dynamic IP address from a DHCP server,
or select static IP to manually assign an IP address to the module here.
Item
Address Type
Static IP Address
Subnet Mask
Default Gateway
MAC Address
Copyright © 2022 ICP DAS CO., Ltd. All Rights Reserved.
Static IP: Manually set the IP Address, Subnet Mask and Default Gateway.
DHCP: Using dynamic IP address that the DHCP server assigns.
Enter an unique IP address on the network that the module is connected. This
setting is available only when Address Type is Static IP enabled.
Enter a subnet mask. (Available only when Static IP is enabled.)
Enter a default gateway. (Available only when Static IP is enabled.)
Enter a new MAC address if required. (Not recommended to modify.)
Description
- 19 -