Table of Contents
Advertisement
Displays
The column of LEDs in the centre of the PCB acts as the main
programming display. In Mode 1 the LEDs can also display the
transmission of channel signals from the module.
1. Channel signals or programming information.
2. Trouble. Lit during tamper, or during trouble with
detectors.
3. Power. Lit steadily when external DC power
present. Flashes when running from backup battery.
Internal Sounder
The PCB carries a piezo electric sounder. During programming
the sounder gives confirmation or error tones.
INSTALLATION
General
Before installation you should carry out a survey of the site. You
need to know how many and what kind of transmitters and or
receivers will be operating through the unit. You also need to as-
sess where the unit must be placed in order to communicate with
the transmitters/receivers successfully. To do this you may need
to conduct signal strength tests using a Scantronic 790r hand
held signal strength meter.
You should also consider the power supply needed for the unit.
Note that the Module does not contain its own power supply.
Cooper Security recommend that you use the 1A power supply
TSPS1.
Siting the Unit
Do site the unit:
Within a protected zone, when used as part of an intruder
alarm.
As high as possible. However, do make sure that the unit is
on a similar level to the other transmitters or receivers.
9
Advertisement
Table of Contents
