Table of Contents
Advertisement
PROGRAMMING
Overview
To program the unit:
a)
Connect power.
b) Enter programming.
c)
Select the required operating mode.
d) Carry out any learning of detectors or teaching of receivers.
e)
Program the detailed behaviour for an individual mode.
f)
Leave programming mode.
Note that if you change operating modes then the unit loses all
memory of any transmitters that it has learned.
Initial Power Up
1.
Fit a 6V 1.2Ah battery to the battery brackets, and connect
the battery lead to the battery connector (4 on Figure 2).
2.
Connect a 12VDC supply to 12V/0V In terminals (6 on
Figure 2).
Caution: Ensure that you connect the power supply to the
power input connector using the correct polarity.
The Power LED glows green.
If you wish to run the unit from the battery only, connect the
battery and then briefly short the kick start pins (5 on Figure 2)
together. This temporarily defeats the battery saver circuit and
allows the module to power up from the battery. The Power LED
flashes while the unit is running on battery only.
Entering/Leaving Programming
To enter programming:
1.
Make sure the tamper switch has opened.
The Red Trouble LED glows
2.
Press SELECT.
The blue LED for menu 1 glows.
To leave programming:
1.
Press ESC/DEL.
The blue LED switches off. The sounder gives a regular
beeping tone to remind you to replace the lid.
2.
Replace the lid (or operate the tamper switch).
After a few seconds the red Trouble LED switches off and
the sounder gives a double beep confirmation tone.
13
Advertisement
Table of Contents
