Advertisement
8750
Introduction
Overview
The 8750 is a plug-in module for the 7510r and i-on40
control units that allows them to communicate over the
Internet using an Ethernet connection to a local switch or
router.
The module must be fitted within the body of the control unit,
which has sockets for that purpose. This manual provides
brief instructions on fitting the 8750. To program the control
unit to use the 8750 please see "7510r Installation and
Programming Guide" or the "i-on40 Programming Reference
Guide".
Installation
Caution: If you are adding the 8750 to a control unit that
has already been installed then first make sure that the
system is completely unset and in installer programming
mode. (This is to prevent the control unit raising un-
necessary tamper alarms when you open the case.)
Fitting The Module To A 7510r
1. Remove mains power from the 7510r.
2. Undo the two screws at the bottom of the case.
Figure 1. Screw Locations
3. Ease the case body from the wall plate.
Caution! Disconnect the ribbon cable from the wall plate
before opening the case completely (see Figure 2).
2
Advertisement
