Operations; To Start; To Shut Off; Initial Operation - Masalta MT24 Operation Manual

Unfolding Handle
To unfold and secure the handle assembly:
1. New machine with folded handle.
2. Unfolding the adjustable handle and lock the screw.
3. Straighten the handle and lock the hinge pin.
4. Tighten the adjustable lever to lock the handle in its fully opened position.
3. 4.
1. 2.
OIL LEVEL AND LUBRICATION—Check the oil level in the engine and gearbox. Engine and
trowel warranties are VOID if this unit is run without oil. The blade have been greased.
FUEL—Fill the fuel tank on gasoline engines with clean gasoline from a safety can. DO NOT mix
oil with the gasoline.

OPERATIONS

TO START

Make sure the safety stop switch is in the STOP position. If it is not, push the lever down to the
STOP position before attempting to start the engine. Open fuel valve under fuel tank (if so
equipped), open throttle approximately half way down and apply choke. Holding unit handle firmly
with one hand, pull the starter rope sharply with the other about (3) times. When engine starts,
open choke and adjust throttle as necessary to keep it running. If engine doesn't start after (3)
pulls, open choke slightly.
NOTE: These starting instructions are general guidelines only. Since many engine options are
available on our power trowels, consult the ENGINE MANUAL included with the unit for specific
instructions.

TO SHUT OFF

Push the safety stop switch down to the STOP position. Close throttle all the way, and turn the
engine switch to OFF position.

INITIAL OPERATION

With engine started as instructed previously and at operating temperature, adjust speed to about
half throttle. Hold the handle firmly with one hand and move the safety stop switch to RUN
position to engage the trowel blades.
FINISHING OPERATION
After floating, allow the concrete to set until it will support the weight of the trowel. Set the pitch to
approximately 1/4" to 3/8" on the blades. If the blades start to dig into the concrete, decrease the
amount of pitch.
4