Introduction; Operating Principle; Delivery Checks; Standard Features - Masalta MT24 Operation Manual

INTRODUCTION

OPERATING PRINCIPLE

The following instructions were compiled to provide you information on how to obtain long and
trouble free use of the unit. Periodic maintenance of this unit is essential. Read the manual in its
entirety and follow the instructions carefully. Failure to do so may injure yourself or a bystander.
DELIVERY CHECKS—Immediately on taking delivery of your new equipment and before
putting it into service.
l
Read the handbook completely—it could save a great deal of unnecessary expense.
l
Read the engine manual supplied.
l Check the general condition of the equipment –has it been damaged during delivery?
l
Check engine oil level.
l
Check fuel levels.
Recommended lubricants are detailed in the Care and Maintenance section.

STANDARD FEATURES

Your new Power Trowel comes standard with many features to enhance productivity,
performance and safety. Listed below are just a few of these features.
SAFETY STOP SWITCH—The switching mechanism of this switch should operate freely and
should always be kept in this condition. With the switch in the OFF position, the engine should
not start or run. The purpose of this switch is to stop the engine in a runaway situation, (i.e. the
operator releasing the handle during operation).
ADJUSTABLE THROTTLE—Located in a convenient location, this push-pull throttle control
can be set to provide any blade speed from 50 to 130 RPM, and located in place at the desired
operating speed.
BENT ARM ADJUSTMENT—Allows blades to be adjusted to compensate for bent arms
caused by dropping or mishandling the trowel. Can be easily adjusted on-site for consistent
finishing.
HEAVY DUTY RING GUARD—Protects operator and unit while providing lower center of
gravity which contributes to unit stability and performance.
CAST IRON SPIDER—Extra strong for insure alignment. Also contributes to lower center or
gravity for increased trowel performance.
FOLDABLE HANDLE—Easy for transportation and storage.
TILT ADJUSTMENT KNOB – adjusts the angle of the blades for different curing stages and
conditions of the concrete. Turning the knob clockwise increases the angle of the blades to the
concrete. Turning the knob counter-clockwise flattens or decreases the angle of the blades.

PREPARATION FOR SERVICE

Before Starting—Your new Power Trowel has been assembled and tested at the factory. However,
before placing the unit into service the following items should be checked:
3