Preparation; Before Installation - Project Source MT-25005L Installation Instructions Manual

CAUTION
• When installing the water inlet strainer, please make sure it is correctly tightened. If not,
water leakage may occur.
• If the bowl becomes blocked, please trip the distribution panel breaker, then remove the
blockage. Otherwise, sewage may spill out because of the automatic flush.
• Use plungers bought on the market to remove any blockages.
• Please flush after each use, including urination. Otherwise, indoor water leakage may occur
due to poor cleaning, bowl blockage, or sewage spill.
• Be sure to wipe off urine, dew, detergent, or water that has splashed on to the floor with a
damp rag. Otherwise, floor stains or corrosion may occur.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Installation requiring the addition of an electrical outlet should be completed by a licensed
electrician.
Estimated Assembly Time: 45 minutes

BEFORE INSTALLATION

INSTALLATION ENVIRONMENT CHECK
1. Before installation, bathroom walls and floor tiles should be built, with a sewage draining exit, and
water and electricity routes preserved.
2. Confirm the distance between the sewage draining exit and wall matches with the toilet bought.
3. Confirm the inlet water pressure is between 14.5 PSI (dynamic) and 108.8 PSI (static), and
inlet water flow is above 4.76 GPF/minute. If not, toilet performance may be affected.
4. Confirm the inlet water temperature is between 41°F and 95°F. If not, the toilet may not function
properly.
INLET WATER VALVE INSTALLATION
1. Before installing a toilet, install HH angle valve (special) from the supplied accessories onto the tap
water pipe. (NOTE: If there is already an ordinary angle valve, you must replace it with the one
provided).
2. With an empty bucket nearby open the HH angle valve and drain dirty water off the tap water pipe,
until clear water flows out. Clean up any excess water off the floor to avoid any additional safety
hazards.
Sewage Draining Pipe
Distance
FORBIDDEN ACTIONS
15/16-in Connector
OR
1/2-in Connector
8
JJ
KK
HH
Angle Valve (Special)