Remote Control - Basic Functions - Project Source MT-25005L Installation Instructions Manual

7.
CHECK TOILET BUTTONS
1. Confirm the power indicator on the side buttons light up.
NOTE: If the power indicator on the side buttons does
NOT light up, it means all functions are not working.
Please use the remote or side buttons to power on the toilet.

REMOTE CONTROL - BASIC FUNCTIONS

• Working mode distinction:
1. Operation mode: Is the working state a of setting. (Rear Wash, Front Wash, Drying, Flushing,
Nozzle Cleaning, etc.)
2. Idle mode: Refers to the idle waiting state in non-operating mode.
3. Standby mode: Press the power on the side of the remote control or side button on the toilet to
enter a standby mode, and the power consumption will be at its lowest.
• Users must have their skin in contact with the sit-down sensor to activate washing.
• If the Fan is set to ON, it will automatically start after user sits down.
• If the toilets functions are not working properly, turn off the power to the toilet for more than 10
seconds then turn the power back on.
1. Water Pressure Adjustment
• 4 settings to choose from. Adjust comfortable Water Pressure by pressing these buttons.
Level 1 - Water Pressure is at 8.7 psi and the water flow is at 0.08 gpf
Level 2 - Water Pressure is at 8.7 psi and the water flow is at 0.1 gpf
Level 3 - Water Pressure is at 10.15 psi and the water flow is at 0.13 gpf
Level 4 - Water Pressure is at 11.6 psi and the water flow is at 0.14 gpf
2. Nozzle Position Adjustment
• 5 settings available for adjusting to the desired satisfied position to clean.
NOTE: Under Oscillating Cleaning, the Nozzle Position Adjustment is unavailable.
3
3. Rear Wash
• Press the Rear Wash button and the nozzle extends out to work. Press the button again to change
the rear oscillating cleansing. The indicator #1 will blink on the remote control making the nozzle
repeatedly swing back to front. Press again to stop the oscillating cleansing and to switch back to
Rear Wash.
4. Front Wash
• Press the Front Wash button and the nozzle extends out to work. The indicator #1 will blink on the
remote control and nozzle will repeatedly swing front to back. Press again to stop the oscillating
cleansing and to switch back to Front Wash.
5. Warm Air Temp Adjustment
• 4 settings to choose from. Adjust Warm Air Temperature by pressing these buttons.
1
4
5
Ambient
Light Sensor
2
13
Side Button
Icons Light
Up After
Power-On
Fan B
Fan