Inlet Water Strainer Cleaning - Project Source MT-25005L Installation Instructions Manual

SERVICE & CLEAN
Spray Tip Cleaning and Servicing
• Press 'Nozzle Clean' button and water sprays out. Press the button again to extend the rear nozzle.
Then press again to extend the front nozzle. Clean the nozzles with a non-abrasive brush.
NOTE: Don't forcefully pull or bend spray tips.

INLET WATER STRAINER CLEANING

1.
TURN OFF WATER SUPPLY
1. When you find that flush water pressure is not
enough or decreases, clean the strainer.
2. Please turn off inlet water valve to stop water
supply.
3. Turn the angle valve handle counter-clockwise
to close the angle valve.
NOTE: It is forbidden to remove the strainer when
the inlet water valve is not closed, otherwise water
may spray out.
Parts Used
A
A
Toilet
Hardware Used
HH
Angle Valve
2.
REMOVE THE STRAINER
1. Remove the strainer cover with a flat-head screwdriver and pull it out together with the strainer
inside. Please refer to pictures for detailed operations.
x 1
x 1
Turn counter-clockwise of the strainer cover
18
A
HH