Troubleshooting; Service And Clean - Project Source MT-25005L Installation Instructions Manual

BUZZER SOUNDS FROM TOILET
• The toilet buzzer is a sound generating device and serves as a medium for the toilet to indicate
the following:
• Buzz 1: Somebody on seat, may respond to all operations.
• Buzz 2: Nobody on seat, may respond to some operations.
• Buzz 3+: Product system faults.

TROUBLESHOOTING

PROBLEM
Crashed
(Indicator light
not on)
Water does not
spray or
Water pressure
is weak
Water is not warm
Seat temp. not
warm
Lid loose
Remote not working 1. Batteries in the remote no longer
Buttons not working 1. The buttons are damaged.
Water leakage
Outage flush not
working
SERVICE & CLEAN
Maintenance
• Before performing maintenance, please unplug the power source.
• Regular maintenance is required to ensure that the product operates at optimum efficiency.
• Please use soft wet cloth to clean the toilet housing and seat. Any dirt that is left on the seat will
need to be cleaned promptly. A neutral detergent can be used if needed.
POSSIBLE CAUSE
1. The outlet is not connected with
the power supply, or the plug is not
fully inserted.
2. The toilet is not powered on after
accidental power outage.
1. Angle valve not opened or slightly
opened.
2. Water level is set to LOW.
3. Inlet water strainer blocked.
4. Spray tip hole blocked.
1. Water level is set to Normal
Temperature.
1. Seat temperature is set to Normal
Temperature or toilet is in idle mode.
1. Loose bolts on the seat.
work.
1. Angle valve, inlet water pipe and
water distributor not properly
connected.
1. Back-up batteries not installed or
the batteries have failed.
SOLUTION
1. Check that power cord is plugged
in. Press the reset button until
indication light turns on.
2. Use the remote or side buttons to
power on.
1. Open the angle valve or adjust
openness.
2. Turn up water level to higher setting.
3. Clean the strainer.
4. Clean or replace the spray tip.
1. Re-adjust to turn up water level to
higher setting.
1. Re-adjust to turn up seat temp to
higher setting.
1. Re-tighten bolts.
1. Replace the batteries in the
remote.
1. Restart or call service for help.
1. Re-connect.
1. Install or replace the back-up
batteries.
17