Project Source MT-25005L Installation Instructions Manual page 14

REMOTE CONTROL - BASIC FUNCTIONS
6. Fan
• Press this button to start the fan and the indicator on the remote control will light up. Press this
button again to end.
7. Nozzle Clean
• Press this button to enter into nozzle cleaning mode. Water will flow out of the nozzle allowing you
to clean it.
• Nozzle clean is only allowable when the seat is not occupied.
• The nozzle will automatically clean the exterior part of the nozzle after a Rear Wash or Front Wash
session. Press this button again to end the session, or it will automatically end after cleaning for 2
minutes.
8
8. Dryer
• Press this button to start warm air drying. Press again to change to movable air drying that swings
back to front, press again to stop the movement of the movable air dryer.
9. Stop
• Stop the current cleaning operation. If the Stop button is not
pressed, the rear washing/front washing will stop automatically
after 2 minutes. Press and hold the Stop button for 3 seconds to
turn off. Turn off the drying function. Otherwise, the warm air will
stop automatically after running for 4 minutes.
10. Dryer Position Adjustment
• 4 settings to choose from. Adjust the Dryer Position by pressing these buttons.
Notice: Under movable drying, the Dryer Position Adjustment is unavailable.
NOTE:
• The fan will turn off when under drying function. The fan will auto open when drying is finished and will keep working for
1.5 minutes after a person leaves the toilet seat.
11. Lady Care
• Press this button to enter Lady Care in idle mode. When set as a default, the water temperature is
set to the highest level 102.2°F. The water pressure is set to 2nd level (8.7 psi, water flow is 0.1 gpf).
To set as default, turn off the power for more than 10 seconds then turn the power back on.
12. Strong Wash
• Press this button to enter the Strong Wash in idle mode. The nozzle extends out and starts to
discharge. Water pressure is at the highest level. Press this button again to end session, or washing
will end after 2 minutes.
11
6
9 10
14 14
7
Fan
Fan
B
NOTE:
• UV sterilization
function automatically
turns on and sterilizes
for 3 minutes after the
toilet seat is not in-use
for 12 seconds. It will
sterilize again every 4
hours. Attention: There
may be differences
depending on the
configuration of the
toilet.
12
Fan
Fan
B