Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Press the memory module down until the memory module snaps into place and the securing clips lock in place.
NOTE:
Repeat Steps 1 and 2 to remove any other memory modules installed in your computer.
Next steps
1. Install the
hard-drive and optical-drive
2. Install the
3.5-inch hard drive
3. Install the
front
cover.
4. Install the
left-side
cover.
5. Follow the procedure in
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
3. Remove the
front
cover.
4. Remove the
3.5-inch hard drive
5. Remove the
hard-drive and optical-drive
About this task
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3) that secures the M.2 2230 solid-state drive to the system board.
2. Slide and lift the M.2 2230 solid-state drive from the M.2 card slot on the system board.
cage.
or
2.5-inch hard
After working inside your
Before working inside your
cover.
or
2.5-inch hard
cage.
drive.
computer.
computer.
drive.
Removing and installing components
25