Steps
1. Align the screw hole on the media-card reader bracket with the screw holes on the system board and the chassis.
2. Align and slide the media-card reader and the bracket into the slot on the system board.
3. Replace the two screws (M3x5) to secure the media-card reader bracket on the system board and the chassis.
Next steps
1. Install the
hard-drive and optical-drive
2. Install the
3.5-inch hard drive
3. Install the
front
cover.
4. Install the
left-side
cover.
5. Follow the procedure in
Power supply unit
Removing the power supply unit
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
3. Remove the
front
cover.
4. Remove the
3.5-inch hard drive
5. Remove the
hard-drive and optical-drive
About this task
The following images indicate the location of the power supply unit and provide a visual representation of the removal
procedure.
34
Removing and installing components
cage.
or
2.5-inch hard
After working inside your
Before working inside your
cover.
or
2.5-inch hard
cage.
drive.
computer.
computer.
drive.