Steps
1. Align the fan shroud over the processor fan.
NOTE:
The side of the fan with the word 'REAR' written must face the rear of the chassis.
NOTE:
The stubs on the fan shroud must align to the corresponding stub holes on the processor fan.
2. Press down on the fan shroud until all the securing tabs snap into position.
Next steps
1. Install the
left-side
cover.
2. Follow the procedure in
Processor fan and heat-sink assembly
Removing the fan and heat-sink assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
3. Remove the
fan
shroud.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the removal
procedure.
After working inside your
Before working inside your
cover.
computer.
computer.
Removing and installing components
41