Firmware Update Procedure; Updating By Dpms - Denon DNP-730AE Service Manual

FIRMWARE UPDATE PROCEDURE

1. Updating by DPMS

Download the latest firmware from the internet and update the firmware.
1.1. Network Connection
(1) System requirements
• A broadband internet connection
• Modem
• Router
• Ethernet cable (CAT-5 or greater recommended)
(2) Settings
Internet
Router
1.2. Check and update the firmware
Check whether new firmware is available. It is also possible to check approximately how long the update will take.
(1) Press POWER button to turn on power.
(2) Press SOURCE button to display menu.
• Press CURSOR d / f buttons select to General. Press the ENTER.
• Press CURSOR d / f buttons select to Firmware Update. Press the ENTER.
• Press CURSOR d / f buttons select to UPDATE.
• Press CURSOR d / f buttons select to CHECK For UPDATE.
(3) Press the ENTER button.
• If the latest firmware has been already installed, press the SOURCE button to close the Update menu.
(4) Press ENTER button. Select YES, then press ENTER button.
(5) To start the update.
(6) When rewriting is completed, this unit restarts itself automatically.
(7) Press the POWER button to turn off the power.
(8) Hold down the POWER button for at least 3 seconds while pressing the CURSOR d button.
This unit sets the version display mode.
Please confirm the firmware version.
(9) Check MAC Address.
Setup → Network → Network Info → MAC Address
(10)The back panel of the unit, MAC Address seals, please change new one.
Please confirm the MAC Address display is corresponding to the seal.
(11)Hold down buttons "SOURCE" button and "CURSOR d " button at the same time and press the "POWER" button to
turn on the power. (
Initialization for the factory
--- Precautions for Updates ---
• The environment and settings must allow connection to broadband Internet for updates.
• Never turn off the power before an update is completed.
• It takes around 1 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
The menu settings of this unit may be initialized.
Take note of your settings beforehand and reconfigure them after the update.
Modem
To WAN port
To LAN port
To LAN port
ETHERNET
connector
)
Computer
LAN port/
Ethernet
connector
AUDIO OUT DIGITAL AUDIO WI-FI
CONNECT
OUT
OPTICAL
R L
WPS
24
IR NETWORK WI-FI
CONNECT
CONTROL
OUT
IR iOS
TO DENON
DCD OR PMA