Procedure After Replacing The Microprocessor, Etc - Denon DNP-730AE Service Manual

PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC

The procedure after replacing the u-COM (Microprocessor), flash ROM, etc. is as follows.
PWB Name Ref. No. Description
MAIN IC113 R5F56108VNFP
MAIN
CY920 MODULE CY920-C (DNP730)
MAIN
IC101 GD25Q32B
MAIN
IC207 MX25L25635FMI-10G
After replacing
A : The software has been written. The software is not written at the time of replacement.
B : The software has been written. The software may need to be rewritten by version updates. Check the version.
C : The software has not been written. The software needs to be written after replacement. See "Firmware
UpdateProcedure" for information on writing the software.
D : The software has been written. Be sure to rewrite with the latest software for your service region. See "Firmware Update
Procedure" for information on writing the software.
After
replaced
B
D
A
C
23
Remark
E1C