Ryobi TSS103 Operator's Manual page 31

CUTTING WARPED MATERIAL
See Figures 40 - 41.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 40.
If the warped material is positioned the wrong way as shown
in figure 41, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 42.
When cutting wide workpieces, such as a nominal 2 in. x
6 in., boards should be clamped with a work clamp as shown
in figure 42.
OPERATION
RIGHT
Fig. 40
31 − English
WRONG
WIDE
BOARD
Fig. 41
Fig. 42