Table of Contents
Advertisement
2.
CLI Commands
traceroute
-O OPTS,... Use module-specific option OPTS for the traceroute module. Several OPTS allowed, separated by
comma. If OPTS is "help", print info about available options.
--sport=port Chooses the source port to use. Implies -N 1. Normally source ports (if applica- ble) are chosen
by the system.
--fwmark=mark Set firewall mark for outgoing packets.
-U Use UDP to particular port for tracerouting (instead of increasing the port per each probe), default port is 53.
-UL Use UDPLITE for tracerouting (default dest port is 53) .
-D Use DCCP Request for tracerouting (default port is 33434) .
-P prot Use raw packet of protocol prot for tracerouting.
--mtu Discover MTU along the path being traced. Implies `-F -N 1'.
--back Guess the number of hops in the backward path and print if it differs .
-V Print version info and exit.
host The host to traceroute to.
packetlen The full packet length (default is the length of an IP header plus 40). Can be ignored or increased to
a minimal allowed value .
28
ETERNUS DSP CLI Reference Guide
Advertisement
Table of Contents
