Reboot; Services - Fujitsu ETERNUS DSP Series Cli Reference Manual

2. CLI Commands

reboot

reboot
WARNING
■ COMMAND NAME
reboot [--wipe|--all|--rollback|--factoryreset]
■
SYNOPSIS
reboot
■ DESCRIPTION
With no options, performs a standard reboot of the node after which the node will re-join the cluster automati-
cally. Rebooting the system does not cause data loss.
■ OPTIONS
--wipe Wipe data and control data.
--all Run on all nodes. Requires working ETERNUS DSP System.
--rollback Roll back the local node to the previous version . Only valid during an upgrade.
--factoryreset Reset of node to the factory state.

services

■ COMMAND NAME
services
■ SYNOPSIS
services
■ DESCRIPTION
Display the status of services running on the node.
Potential Data Loss.
• Issuing the reboot command can result in data loss from the ETERNUS DSP
System.
• Some of the reboot command options delete data and are intended to be used
only after a node is properly decommissioned. You must decommission a node
before you disconnect and permanently remove the node from the ETERNUS
DSP System. Failure to decommission the node can result in data loss from the
ETERNUS DSP System. For more information about decommissioning a node,
see the ETERNUS DSP User's Guide or GUI Help.
22 ETERNUS DSP CLI Reference Guide