Table of Contents
Advertisement
Turn the power switch "OFF" and disconnect the plug from the outlet prior to adjusting or maintaining
the machine. DO NOT attempt to repair or maintain the electrical components of the motor. Contact a qualified service
technician for this type of maintenance.
1. Before each use:
- Check the power cord and plug for any wear or damage.
- Check for any loose screws, hardware, locking handles,
jigs or various lathe accessories.
- Check the area to make sure it is clear of any misplaced
tools, lumber, cleaning supplies, etc. that could hamper the
safe operation of the machine.
2. Avoid a build-up of wood shavings and dust. Regularly
clean all parts of the machine using a soft cloth, brush or
compressed air. A general cleaning should be done after
every use to avoid future problems and ensure that the
machine is in ready condition for its next use.
WARNING: If blowing sawdust, wear a proper dust mask
and eye protection to prevent debris from being inhaled and
blowing into your eyes.
TROUBLESHOOTING -
DISPLAY
CODE
CONDITION
Digital RPM Display is not operating.
00
Software Protection Mode - Possible damage to
02
the electronic controller. Short circuit protection.
Spindle Direction Protection Mode - The spindle
06
direction has been changed during operation.
See page 22 for the 70-1420VSR Wiring Diagram, and page 5 for additional electrical information.
MAINTENANCE
3. Keep the lathe bed free of resin and rust. Clean it
regularly with a non-flammable solvent, then coat with a
light film of dry lubricant spray, or wax, to enhance passage
of the tool rest and tailstock on/over the bed.
4. Keep the lathe tools sharp, and make sure the steel is
not loose in the handles so that no accidents might occur.
Making sure that tools are in proper operating condition
will ensure that the quality of your turning will be the best
possible.
5. Check all lathe accessories (spur centers, live centers,
chucks, tool rests, etc) to ensure that they are in perfect
working condition.
6. The lathe's ball bearings are lifetime lubricated, sealed,
and do not need any further care. Keep the drive belt free
of oil and grease to prevent slipping on the pulleys.
Electronic Speed Control ACTION CODES
- Check wiring connections to the RPM reader.
- Check & clean the RPM reader for any dust build-up.
- Check drive belt. Adjust RPM reader or drive belt positions.
- Check that the motor wiring is not loose and wired correctly.
- Turn off the machine and re-start once the digital display has
cleared. If the error code still appears, the controller hardware
may be damaged and Technical Support should be contacted.
- Turn off the machine and re-start it once the digital display
has cleared.
NOTES
16
ACTION
Advertisement
Table of Contents
