ASSEMBLY
Locking ring
®
ACCU-SCOPE
3025-2F MULTI-VIEWING MICROSCOPE SYSTEM
Lock screws
Fig. 1
Fig. 2
Fig. 3
Mounting the Illuminator
(Fig.1, Fig. 2 & Fig. 3)
Attach the illuminator to the back of the
microscope as shown (Fig. 1); using the
enclosed Allen wrench (3mm), tighten the lock
screws on both side by turning clockwise.
Insert the end of the power cord from the
illuminator housing into the base of the
microscope as shown in (Fig. 2); tighten the
locking ring by turning it clockwise until it stops.
The illuminator assembly is complete (Fig. 3).
4