Muratec MFX-2500 User Manual page 93

Descriptions
A. Service start setting
This setting determines whether to activate the SNMP Agent function or not.
Activation of this function enables remote management of device information via the
management software.
When the function is not activated, all settings described below are made ineffective.
B. Agent identification
The settings are reflected in the MIB system group.
Each field can be entered with up to 255 characters.
[Contact destination]
: Enter the name of the manager to be contacted and the contact method
regarding the relevant managed node.
[Name] : The name is for management purposes.
Enter the full domain name of this node.
[Location]: Enter the location of the relevant managed node.
C. Security
This is the setting of the host computer that accepts the SNMP packet.
When requests from all the hosts are to be accepted, set their community name.
If a request from a specific host is to be accepted, set the IP address and the
community name of the host. Up to 3 hosts can be registered.
D. Trap transmission destination 1-3
This is the setting of whether to send a TRAP or not. Up to 3 destinations can be
registered.
If a TRAP is to be sent, at least one destination must be registered.
Enter the destination IP address, and choose the event level for TRAP issuance and
whether a consumables ordering event is to be posted or not.
The community name can be entered in up to 20 characters.
[SET] button
Click this button to register the entry.
[REDO] button
Click this button to retrieve the current settings.
[INITIALIZE] button
Click this button to restore the initial shipment settings.
Chapter 6 Linkage with other systems
6
83