Table of Contents
Advertisement
LISTING OF WARNINGS, CAUTIONS AND
SYMBOLS
The following is a listing of the safety precautions which must be observed when uncrating and installing this
equipment. WARNINGS indicate the potential for danger to personnel and CAUTIONS indicate the potential for
damage to equipment. These precautions are repeated (in whole or in part), where applicable, throughout the
instructions.
WARNING - PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD:
When moving the unit, use a forklift.
Only fully qualified service personnel should assemble and/or make adjustments to this
equipment. Assembly or adjustments done by inexperienced, unqualified personnel could cause
personal injury or result in costly damage.
WARNING - LACERATION/EYE INJURY HAZARD:
When removing bands, wear gloves and eye protection, and always use a tool specifically designed
to cut the bands. The bands used to secure cartons can cause personal injury when cut and tension is
released.
WARNING - LACERATION HAZARD:
When removing bolts, wear gloves to protect your hands.
WARNING - PERSONAL INJURY HAZARD:
When baskets are present on load conveyor, keep fingers/hands away from wash chamber and
moving baskets.
WARNING - ELECTRIC SHOCK AND BURN HAZARD:
Disconnect all utilities to unit before servicing. Do not service the unit unless all utilities have been
properly locked out. Always follow OSHA Lockout-Tagout and electrical safety-related work practice
standards. (See 29 CFR 1910.147 and .331 through .335.)
CAUTION - EQUIPMENT DAMAGE HAZARD:
When removing adhesives from stainless steel, use a small amount of nonflammable cleaning
solvent. Rub in a back-and-forth motion (in same direction as surface grain). Solvent rubbed in a circular
motion or applied with a wire brush or steel wool on cabinet assemblies can be harmful to stainless steel. Do
not use solvents on painted surfaces.
When leveling load/unload modules, use ONLY the module leveling legs. DO NOT RAISE OR LOWER
WASHER LOADING RACK FOR ANY REASON. Washer loading rack is adjusted and inspected at factory to
ease installation procedures.
Observe the Electrostatic Precautions outlined in Section 3. Always wear a grounding wrist strap
when removing or replacing PC boards or ICs.
Listing of Warnings and Cautions
Uncrating/Installation Instructions
1
1-1
122994-142
Advertisement
Table of Contents
