Table of Contents
Advertisement
Installation Instructions
8. Press CURSOR touch pad to select lt. Press VALUE UP touch
pad to energize the interior light.
9. Press STOP/RESET touch pad. Display shows:
I/O OUT
10. Using the CURSOR touch pad, select I/O OUT and press
CYCLE START. Display shows:
I 0 dv fn p1 --
--
(display may vary depending on options)
11. Adjust X10 proximity sensor on load end of washer. Sensor end
must be at least 1/16 " from door open proximity sensor target
(see Figure 3-6). Open and close load door to check setting (to
close load door, select LD and press VALUE DOWN touch
pad).
12. Adjust X11 proximity sensor on load end of washer. Sensor
end must be at least 1/16" from door open proximity sensor
target (see Figure 3-6). Open and close load door to check
setting (to close unload door, select UD and press VALUE
DOWN touch pad).
IMPORTANT:
Make sure that each sensor detects door only
when door is fully open (LED on back of sensor lights up). While
door is in motion, make sure that top portion of door is not being
detected by the sensor.
13. Once the sensors are correctly adjusted, tighten each locknut
to hold sensor in position.
14. When load/unload modules installation and door proximity
sensors adjustment are completed, press STOP/RESET touch
pad until Service Mode main menu is displayed.
TESTS
CALIBRATE
THIS COMPLETES THE INSTALLATION. Before operating
equipment, Installation Checklist (Section 4) and Operational Test
(Section 5) should be conducted by a qualified service technician.
Uncrating/Installation Instructions
CRTL OUT
--
--
--
-- -- LD UD wc
BURN-IN
VALUES
3-17
122994-142
Advertisement
Table of Contents
