Adjustment Of Door Proximity Sensor - Amsco RELIANCE 444 Installation Instructions Manual

Adjustment of Door
Proximity Sensor
3-16
122994-142
*SERVICE TEST
RELIANCE MODEL 444
then...
TESTS
CALIBRATE
NOTE: Make sure end of each Door Open sensor clears opening
in door frame (see Figure 3-5).
1. Press CYCLE START touch pad. Display shows:
OUTPUTS
TPS TEST
2. Press CYCLE START to select OUTPUTS. Display shows:
I/O OUT
3. Press CYCLE START to select I/O OUT. Display shows:
I 0 dv fn p1 --
--
(display may vary depending on options)
4 Press CURSOR touch pad to select ld (load door)
.
UP touch pad to open washer load door.
5. Press CURSOR touch pad to select ud (unload door). Press
VALUE UP touch pad to open washer unload door.
6. Press STOP/RESET touch pad. Display shows:
I/O OUT
7. Using CURSOR touch pad, select CTRL OUT and press CYCLE
START. Display shows:
CB cw hw ls
lt ps
Uncrating/Installation Instructions
BURN-IN
VALUES
INPUTS
VALUES
indicates flashing position.
CRTL OUT
indicates flashing position.
-- --
-- -- -- ld ud wc
indicates flashing position.
CRTL OUT
hs ss cd
df dh --
Press VALUE
.
Installation Instructions