Table of Contents
Advertisement
Pneumatic Connections
3-10
122994-142
Figure 3-7. Pneumatic and Electrical Connections
Uncrating/Installation Instructions
NOTE: When connecting modules to an existing washer, shut off
and bleed existing air supply line before disconnecting from washer.
1. Run a 10' long translucent hose (1/4" OD) from C2 service
compartment to washer service compartment. Run hose up
through the cabinet channel, located along side of washer door,
to the main air supply line filter/regulator located near top of
washer (see Figure 3-7).
IMPORTANT: Make sure hose does not interfere with operation of
the washer door cable.
2. Connect A1 hose end to washer main air supply line filter/
regulator by pushing back the connector's outer ring, inserting
hose and releasing outer ring (see Figure 3-7). Connect Cus-
tomer air supply line to the other end of the tee.
Ref.: 122-994-091
Installation Instructions
Advertisement
Table of Contents
