Table of Contents
Advertisement
Figure 3-6. Check Distance Between Water Inlet Collar
Spray Head and Drain
Connections
Installation Instructions
and Loading Rack Sliding Guides
1. Locate CW2 pipe end (cold water supply to spray head) in C3
service compartment (see Figure 3-3). Run piping under washer
to C2 service compartment, and connect to CW2 elbow located
on C2 spray head compartment.
2. Connect CW4 hose end to elbow under the cold water supply
valve in washer service compartment (see Figure 3-3).
3. In C3 service compartment, locate drain hose with plastic tee.
Remove funnel plug in washer drain. Run hose end to washer
service compartment and connect D2 tee to washer drain funnel
(see Figure 3-3).
4. Locate D1 hose end in C2 service compartment. Run hose end
to washer service compartment and connect D1 hose end to
plastic tee (see Figure 3-3).
Uncrating/Installation Instructions
3-9
122994-142
Advertisement
Table of Contents
