Table of Contents
Advertisement
operations
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses, face shield and respirator when
operating this machine.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
-16-
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for grinding.
2.
Correctly installs desired grinding wheel for
operation.
3.
Properly secures workpiece in lathe.
4.
Makes sure tool post grinder is setup cor-
rectly.
5.
Turns lathe ON.
6.
If necessary, begins coolant flow to workpiece.
7.
Turns tool post grinder ON.
8.
Using lathe slide controls, slowly feeds grind-
ing wheel into and along surface of workpiece.
9.
When operation is complete, turns lathe and
grinder OFF.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model T27400 (Mfd. Since 02/15)
Advertisement
Table of Contents
