Grizzly T27400 Owner's Manual page 25

4. Remove hex nut (see Figure 15) securing
external spindle pulley, and then remove pul-
ley.
Note: External spindle pulley (see Figure 15)
screw has left-hand threads.
Belt
Tensioning
Cap Screw
External Spindle
Figure 15. Belt guard removed.
5.
Loosen wheel guard cap screw and remove
guard from spindle.
6. Remove (2) cap screws securing spindle
(see Figure 12 on Page 20), allowing assem-
bly to slide free of tool grinder housing.
-22-
External Motor
Pulley
Hex Nut
Pulley
7.
Remove external wheel spindle and install
internal wheel spindle.
Note: A standard screwdriver may be needed
to lightly separate gap in tool grinder housing
allowing spindle to slide free.
Tool Grinder Housing
Internal Wheel
Internal Wheel Nut
Figure 16. Internal grinding wheel installed.
8.
Align grinding wheel spindle with motor pul-
ley. Refer to Tensioning/Changing Belts on
Page 20 for belt alignment and tensioning.
Model T27400 (Mfd. Since 02/15)
Wheel Guard
Internal
Spindle
Flats